With the electronic measuring device 09905 the vehicle level is registered via the position of the transverse links respectively the axle drive shafts or areas of support in the degree of angle. In addition to the determined angular values (in degree decimal) the reference variables can then be allocated concerning wheel camber, caster and toe. Upon measuring the supporting surfaces you receive the angular deviation withregard to the horizon, e.g. aligning or verifying of a wheel alignment stage. The electronic measuring device also serves for the measurement of the buckling angle of a drive train. The following angles are measured with the instrument: Absolute angle of the transmission, of the propeller-shaft (1+2, in cases with 3 i.e. rescue vehicles) and of the rear axle middle piece.

Description:

Application Example on the Front Axle
To acquire the data of the lower transverse links a simple adaptation plate is required. By means of this adaptation plate a defined supporting surface is created for the inclinometer. Insert the adaptation plate in the sparing on the left lower transverse link and align it. Put on inclinometer (indication is effected via the display of the operating device) and store the measured value. Repeat the work steps on the right lower transverse link.

Application Example on the Rear Axle
The data of the inclination of the rear axle shafts are acquired via the conical contours of the inclinometer. View from the vehicle middle to the left rear axle shaft. Put inclinometer directly from underneath onto the left rear axle shaft and store the measured value. Repeat work step on the right rear axle shaft. Reprint or reproduction allowed only with authorization through the manufacturer.

Technical Data:
Sensor for the measurement of 2 levels, micro processor controlled
Measuring range: +/- 15.5°horizontal level (x-drivin g direction) Resolution: 0.10°(inclinometer)
+/- 7.5° vertical level (y-right angle to driv.-d ir.) 0.020 (buckling angle)
Linearity: 0.035 % Measuring precision: 1 %
Temperature range: 0-70°C Interface: RS-232, USB
Power supply: ca. 4.8 – 6 Volt/0.8 Watt Type of protection: IP 65
Charging socket for the supply unit: 12 V, ca. 250 mA for charging 4 x 1,2 V NiMH-rechargeable batteries
Dispatch (LxWxH) in mm: 450 x 378 x 90
Weight: about 4.5 kg

Scope of delivery:
Operating device with display, power supply, standard adapter for inclinometer 09606-50 and standard
adapter set for propeller-shaft-buckling angle measurement 09935-25, carrying case.

Accessories:
Data transfer and charging station with power supply, data cord (9 pole, 1.2 m length),
order-no. 09630-10 (220 V)/09630-11 (110 V).